BSK

Programming remote unit

- Switch ignition ON.

- Lock vehicle mechanically at left front door using second key.

- Press "Open" button on first remote unit (key fob) once (to assign memory address to remote unit number one).

Note: The alarm horn will sound briefly each time the "Open" button is pressed to confirm the reception of the signal during this process.

- Wait six seconds after sending last signal, then press "Open" button again.

^ Doors will now unlock (remote unit is now programmed).

- Lock vehicle mechanically again using second key.

- Press "Open" button on second remote unit (key fob) twice at 1 second intervals (to assign memory address to remote unit number two).

- Wait six seconds after sending last signal, then press unlock button again.

^ Doors will now unlock (2nd transmitter is now programmed).

- Repeat procedure for additional remote units (key fobs) to assign memory addresses number 3 and 4 if necessary.

- Switch ignition OFF.

- Check each transmitter for proper function